how ct burden,magnetising current,ratio and knee point
voltage are related & derived
No Answer is Posted For this Question
Be the First to Post Answer
how techometer works and how it will be connected above the flywheel in dg system
why the NGR (neutral grounding resistor) always OFF during DG off?
I have installed capacitor bank at secondary transformer. cos phi is increase. but on load (far from transormer), it still poor. Can anybody explain it??
why lightining is not available in swith yards?
IN CABLE TRENCH WHY FILL UP THE SAND. AND WHAT IS THE DIFFERENCE BETWEEN OVER HEAD AND UNDER GROUND LAYING THE CABLES
how calculate cable size in squre mm, when the load is given by in kw? do u have current rating chart of elctrical cables?
what is The difference between national electrical code and I.S.Code (electrical) and what is the value of NEC in electrical engineering field
Diagram on interconnectivity of 11kv transformer with RMU (i.e, one incoming and two outgoing or two incoming and one outgoing)
what is means of CLASS in current transformer name plate?
How short circuit MVA(Fault MVA) in a power system calculated for calculating number of earth plates ?
what is auto transformer?
Transformer Parallel Operations
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)