If drainage is main things then which respect the super
Elevation may be provided?
Answers were Sorted based on User's Feedback
Answer / sjtbehera
Super elevation are provided mainly in a curve surface.
Drainage is the not main cause.In super elevation the outer
edge of the road is raised in respect to inner
edge.Drainage are provided for water flow. so road are
slope in respect to drain so that water can easily flow.
No super elevation are provided for drainage.
| Is This Answer Correct ? | 7 Yes | 1 No |
Answer / ifelola
Super elevation curves are provided to counter the effect
of centrifugal forces at curves to avoid skiding
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / j ritesh naidu
superelevation is provided at curves to compensate the forces generated on moving object while it is turning ....otherwise the moving object has to slow down its speed in worst case the moving object may skid or even topple...super elevation on curves helps the moving object turn along the curve without reducing speed
drainage has no connection with superelevation ...for drainage part ,cross drainages along the road r provided
| Is This Answer Correct ? | 0 Yes | 0 No |
how many bricks consume for one cft with wastage
What is the bar bending schedule
what"s the merits and demerits of hollow blocks comapre than to bricks?
To pcc 11 ft x 24 ft .How many bags of cement, sand and aggregate required? And for roofing how many cgi sheets required?
pointing raju,ayesha says"he is the son of my mother's brother's wife". how is ayesha related to raju?
What are some facts about concrete?
WILL ANY COLLEAGUE TELL ME THAT WATER RATIO IS FIXED FOR ANY TYPE OF CONCRETE? OR HOW CAN WE DETERMINE THE RATIO OF WATER IN A CONCRETE MIX.
why either no or minimum shear reinforcement is provided in case of slabs?
what is the code provision for acceptance of fineness modulus range for fine aggregates in design mix
How to calculate lap,bond and hook length for preparing bar Bending schedule ?
11 Answers L&T, Saudi Aramco Shell Refinery Company SASREF, Sunil Hitech Engineers, Tempus, Zain United Arabian,
1. What is coefficient use for calculation of shuttering. 2. What is coefficient use for calculation of reinforcement in one cum of concrete.
How much percent of steel use in concrete members etc.slab,beam,lintal,colmn,raft fondation according to concrete volume? Kindly reply me I am in dbout plz
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)