WHAT HAPPENING TO TRANSFORMER????
i have the step down transformer rating 230/12v, power
rating something.,,, ok. suppose iam giving 12v to secondary
side,what will happen on primary side.,,,
Answers were Sorted based on User's Feedback
yes, it can be used as step up transformer also,provided
loading should not exceed the rated kVA
Is This Answer Correct ? | 7 Yes | 1 No |
The design of transformer are rating in terms of insulation
of core & winding configurations
in 230v/12v transformer the primary winding(230v)
nearer to core & (12v)winding at outer layer
so it is not possible for to step up value to 12v to 230v
by input 230v ac in secondary site(12v)the winding
insulation burn up.
@Ramesh
Is This Answer Correct ? | 3 Yes | 0 No |
Answer / raju.be10@gmail.com
Winding Depend Produced voltage of TRANSFORMER
Is This Answer Correct ? | 1 Yes | 0 No |
Answer / mujeeb
THE TRANSFORMER SHOULD STEP UP THE VOLTAGE ,IF AND ONLY I
THE SECONDARY VOLTAGE IS AC ,THE INSULATION OF THE CORE
ALSO COES INTO PICTURE ,SO THE VOLTAGE WHICH IS AVAILABLE
WILL NOT EQUAL TO 230V AC.BECAUSE THE VOLATGE 12V HAS TO
BEE FEED TO THE PRIMARY WILL HAVE INULATION LESS THAN THE
PRIMARY SO TRANSFORMER GETS HEATED IF U DO IT FOR LONGER
TIME........
Is This Answer Correct ? | 0 Yes | 0 No |
which type of breaker sould be used for different level of voltage ? (i.e at 11 Kv, 33 Kv, 66 Kv....
we have 15 ampere variyac but we want 30 ampere variyac what we do
2. What are the parameters of EHT sub-station?
what is excitor response of an excitor?
why low pressure side of the turbine is connected to the alternator and not the high pressure side??
why we are testing cables with DC supply not with AC supply?
9 Answers Aurobindo, DEWA, L&T,
Current Transformer's star point must face the protected object for the relay operation?
How the speed of synchronous motor changes with the variation of load?
what is the isolation transformer. what is the isolator?
in 11kv/400v transformer when only one phase of 11kv supply fails what happens to sec voltage and why
onan full form
how we can classify the circuit braker???????