Interested to Buy Any Domain ? << Click Here >> for more details...
WHAT HAPPENING TO TRANSFORMER????
i have the step down transformer rating 230/12v, power
rating something.,,, ok. suppose iam giving 12v to secondary
side,what will happen on primary side.,,,
- 6 Answers
- 10237 Views
- Coastal Energen, I also Faced
- E-Mail Answers
Answer Posted / vincent
you will get 230v if 12v supplied was AC
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
Who many reason of ignition fail ?
Why a tesa lamp is glow between two phase?
Explain about how is it working Earth fault'relay and wahts the resistance value of earth bed
in the case of 6.6kv motor starter combination contain fuses on it VCB. but in 11KV motor starter combination Fuses are not using in it's VCB why?
why actual valve timing diagram is different than ideal valve timing digram of a 4 stroke engine?
What is the basis for selecting Vk/2 or Vk/4 for REF and Differential protection of Transformer and What is the significance of magnetising current
Purpose of providing neutral isolation panel for parallel operation of diesel generator
we are small scale industry in production of rice & rice bran. Pls let me know how to take contract demand for our industry.. (for information we have total 600.hp)
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
What is Negative Potential Bias
How to assume answer to electrical questions
Can anyone explain me about the RLC based Impulse high voltage generator and how to and operation of Series resonant High voltage reactor...?
after how many spot we must chang secondry cable in portable spot welding gun?
What is process of anneling transformer core
As a electrical engineer.. what are the basic norms should follow in transformer oil testing.. 1.What is the Electrode type? 2.How long time you will give for oil testing?
