WHAT WILL HAPPEN IF WE START A MOTOR WITH STAR & IT IS
RUNNING WITH STAR CONNECTION INSTEAD OF DELTA
Answers were Sorted based on User's Feedback
Answer / mrt
we can start the motor either in star ot delta. in star
line current is equal to phase current and the line voltage
is 1.732 times the phase voltage . so the appplied voltage
is low so the magnetic field is low and motor runs in lower
speed with more current.
| Is This Answer Correct ? | 7 Yes | 0 No |
Answer / mahavir jagdev
with the lower voltage being applied to the stator winding it will keep on running at slow speed.
| Is This Answer Correct ? | 3 Yes | 1 No |
Answer / rajib
As the applied voltage is 1/1.732 times, so the torque
produced is less, so less output is there.
| Is This Answer Correct ? | 0 Yes | 0 No |
Why we transmit the power at the voltage in the multiple of 11 or 1.1 like 11kv, 22kv, 66kv, 132kv...... some one told me that it is due to fomr factor 1.1 of sine wave. its fine but while transforming we can choose any voltage, so why only multiple of 1.1 there also.......? plz tell me.
what is pressure relief valve?where it is used????
in 3 phase (4 wire) star connection - is current pass through neutral??
Define heating time constant of electric motor.
I know current,volt,powerfactor of an electrical line. In this line how I will calculate Active power and Reactive power
Explain the iniluencc of short circuit ratio on the pert'orniancc of synchronous machine.
i have one source transformer with the capacity of 50KVA, connected with two loads 10kw and second one is 15kw.. how can i calculate first load in KVA and second one in KVA .. because Kva rating, power factor rating of of transformer is different from the load… there must be some way to calculate load KVA rating and power factor….
What is the winding resistsnce need to be in a 1000kva, 11kv/415v transformer, between ht winding to lt winding, ht winding to earth, lt winding to earth.?
why do you give the dc supply to field of alternator
what is synchronous speed.? if an induction motor is made to run at full load, then is this synch. speed too..?
what is Use of Stones/Gravel in electrical Switch Yard??
What will happen if we on 200kvr capacitor bank(11kv in bus)If there is low load on transformer (1.5 mva 33/11 kv)
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)