What is reason of rating of transmission line multi pal of 11 like as 11/33/66/220 ? Why not use 75 kv 23 kv line in power system ?
1 3411Dear All, In a 400V power system, ratio of three current transformers installed incoming switchgear is 4000/1. Maximum three phases short circuit current of this system is 48kA. One CT is installed on neutral of upstream transformer (6/0.42kV, solidly earthed) for 51G protection. Would you please inform me about the correct CT ratio of this current transformer (on neutral)?? Thanks a million
2 4660The gauge indicates the number of amps, but what about voltage? How voltage rating (for wire or fuse) determined?
1941What will happen to magnitude of voltage of other two phases if one phasw will touch the ground?
3 6032Short circuit current of 2500 KVA 11/0.415 KV transformer both Secondary and primary side. best regards. Ali
1 3743Post New Electrical Engineering Questions
are there rmu for 3 transformer?
Explain the following and how these are working with PLC Unit 1 I/O Module Card 2 Adaptor Card 3 Ribbon Adaptor 4 I/O bus 5 I/O Devices
What is the function of interposing current transformer?
What is the method for testing the differential protection stabilty in generator? When the time of starting What will happen if differentail protection connection wrong means?
what is under coal gassification?
what is the reqirred voltage in HT motor to get full RPM on no load test?
On a 6 KVA UPS we have to provide a DC MCB for Battery bank of 16 nos (12 V 42 AH). What Shall be the current rating of DC MCB ?
Give details of your interested designation, the post you are interested to serve the company better and explain why you think you can serve the company better in such position if employed?
I have two PLC processors. I want to communicate both processor with each other. How i can do so?
What is lc oscillator?
How phase to phase voltage comes 440V.
1))why we run three phase or three different circuit from a single conduit 2)) why not two circuit of different phase run in same conduit?? and why we run same three cicuit of same phae run in single conduit??
How can find thermal state value in relay for calculate thermal overload.
How to dimensioning SDCCH, LAPD and CS7 signaling on GSM?
Explain the process of commutation in a dc machine.