Please tell me ceilingfan sweep means. Commenly we used sweep1200mm and 600mm MMENLY WE USED CEILINGFAN SWEEP1200MM AND SWEEP600MM
1 15243we want install 11KV generator to supply power 12km far from the power house.Load to be fed is 1MW.which conductor should we use and wat will be transmission line losses?
1 4785what will happen if we will not use commutater means if we will give dc to the windings in dc motor
1 5510I AM A ELECTRICAL PANEL BOARD DESIGN ENGINEER.IF I GO ANY INTERVIEW ,TECHNICALLY WHAT ARE QUESTIONS I WILL FACE FROM INTERVIEWER?
Bell,
12941can a 50 Hz transformer work satisfactorily if placed under 60 Hz,what are the prices and losses that will arise
5 7525What should be the length of transmission line so that we can see/obtain the full sine wave of voltage??
1942Post New Electrical Engineering Questions
2. A current i=(10+10 sin t)amperes is passed through MI type ammeter. its reading will be.........
how to select battery for 15 KVA UPS with formula
how to calculate the lightning arrester conductor @ no of earth pits required
what is the minimum requirement gigaohms for the insulation test using 5kv in 300mm xlpe cable
thyristor controlled APFC panel design parameter?
what are different types of electrical windings? i know the distributed winding ,concentrated winding etc but i want some detailed information, in what condition we will use distributed,concentrated windings what are the difference between them which is best, how induced emf changes by using different types of windings 20 hours ago - 1 week left to answer
what is the difference between 2 way and 4 pole selector switch???
If we have 11 kv RYB Phase single core cable near about. Then wht effect and losses
if the number of poles generated in stator and rotor side of an induction motor are different then what will happen and why?
harmonics filter
Hi,iam a diploma in electrical engineering.rtd from indian air force in apr 2007.prsently working in reliance next link as a network maintenance engineer since 2007,can i get a job in motherson sumi.
we have 2.2kw,Y,3000rpm motor but 6leads found in TB what happen if we connect in delta?
how to synchronize 3 phase slip ring induction motors of different ratings.
how to make an earthing certificate
mccb service sittings be done?