-
Civil Engineering (5085) - Mechanical Engineering (4451)
- Electrical Engineering (16632)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
slipring induction motor starting time Lrs operating why lrs starting time lrs outer body didn't get shock
1467Can we get the outpot in c without using getch fiction? Answer is yes but output will stay on display 4 only few second.... But can we get output without using getch and also output will hold on the display...?
1 2067Question 8 - A local utility burns coal having the following composition on a dry basis : Carbon (C) 83.05 %, hydrogen (H) 4.45 %, oxygen (O) 3.36 %, nitrogen (N) 1.08 %, sulfur (S) 0.7 % and ash 7.36 %. Calculate the ash free composition of the coal with reference to C, H, O, N and S.
1 4694Why we. Don't measure current in parallel? Why we measure current in series and why we measure voltage in parallel only?
2 4317
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
WHAT IS THE MEANING OF FLASHING VD AND FD INSTALLATION PLENIUM BOXES IN CENTRAL AIR CONDITION
how configur net and vpn on cisco product
what is the eligibility criteria of mico bosch
How many cylonders are there in 2stroke diesel engine?
Dear All,I have RRB exam on 19th dec Plz send me the Last 5 years RRB Q&A of Electronics & communication Dept to mail id sham28sharieff@gmail.com.. please frnds if u do have the Q&A.. Plz send it..
whats the allowed tolerance of pipe to pipe butt joint mismatching
how much efficiency loss will tool place in a steam turbine due to low vaccum?
in sulfur process what is material of impulse line we use to connect with transmitter ? and does teflon affected by sulfur?
can oracle driver be directly connected with odbc driver??
How to identify the vitrified tile and ceramic tile by observation only after executing the job.
What is the difference between automotive production and mass-production.?
What is forced convection?
Define holding current?
what is difference between Fault tolerance Vs fault avoidance
