Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379) What types of CMOS memories have you designed? What were their size? Speed? Configuration Process technology?
AFG, Afghan Telecom, GE, IBM, SECL, Sun Pharma, TNPL,
3701What work have you done on full chip Clock and Power distribution? What process technology and budgets were used?
2780What types of I/O have you designed? What were their size? Speed? Configuration? Voltage requirements? Process technology? What package was used and how did you model the package/system? What parasitic effects were considered?
2300
interface an 8-pin switch with 8085 microprocessor located at 0AAH and LEDs at port 55H, draw the circuit diagram. Write down a program to read the switches and do the following: > if the parity of the switch is odd, start counting upward until it reaches 0FFH. > if the parity of the switch is even, start counting downwards until it reaches 00H.
Is there a diode made that works with AC 120 volt 20 amp? If so can it completely stop all current flow in 1 direction at all times?
hi friends can u plz give me some tips on how to prepare for technical interview in E.C.I.L.
i want design of D.C.MOTOR 1HP 960RPM AND 2HP 960RPM ITS URRGENT
send interview questins about pro_e to me mohanrvs_1984@yahoo.co.in
In order to find out stack fault of a three input nand gate how many necessary input vectors are needed ?
what is the sludge current
Isometric drawings are generated during _________________ phase of a project
Enumerate the cause of pumps low delivery of water
What is meant by stator?
is it possible to hook up a computer flat screen to a fishfinder?
71ohm,111ohm,95ohm,179ohm in calculate the total ohm in series circuit
Can we integrate the C programming with Pro-e (modelling software)through application program?
What denotes the 5/8mm in the 3300XL 5/8mm proximitor probe?
I want technical questions of previous reqruitment examination