Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379) If I want to connect a capacitor bank on the HT side of a 11kV/415V, 3 phase delta-star distribution transformer to supply Reactive power to it..what practical specifications of a Capacitor bank that can i've??please reply..
2499minor loss due to sudden contraction 1>flow contraction 2>Expanssion of flow after sudden contraction 3>cavitation 4>boundry friction
1 3915the bubble tube parallel to the telescope of theodolite should be more sensitive since it controls a. vertical axis b. horizontal axis c. axis of bubble tube d. none of this
4 15820nitrates more than 45 mg/l in water lead to disease called gastroenterities motteled teeth polio none
1 6384cross hairs in surveying telescope are fitted in the objective lense at the center of the telescope at the optical centre of eyepiece in front of the eyepiece
2 7366shearing strength of cohesionless soil depends upon dry density rate of loading confining pressure all above
1 6256undisturb samples are obtained by direct excavation thin walled sampler thick walled sampler none of this
1 3729relation bet Coefficient consolidation Cv, time factor Tv, drainage path d, & time t is Cv=d2Tv/t Cv=d2t/Tv Cv=tTv/d2 Cv=Tv/td2
SSC,
2996
What is cut off relay? And why use in PLC and DCS?
What is resonant peak?
Basic civil interview questionsÂ
what will be the min and max voltage flow from neutral to earth?
how to calculate regulation constants for over head lines? and what are the regulation constant for raccoon conductor at different voltage level and different P.F?
How can calculate the rating of a servo stabilizer for given a specific load
Why is a plain induction motor unsuitable for wide speed control?
Discuss about the various tie & Die methods.
If I have Energy Meter Ratio as 100:5 & Also I have CT Ratio as 50:5 then what will be my multiplying Factor(M.F.)
Disadventage of cable-gland earthing if any ?
How much the quantity of Dry material of Crush for 1:2:4 Concrete, using pan 3/8'' down....
What is meant by sequence control of ac voltage regulators?
I have an span length 16 ft c/c
I have to design brick column and footing (note: without any reinforcement). Can somebody post me the design or suggest a book where i could possibly find the design? Plz help very urgent
1.what is mean by 8/20 micro sec waveshape