What are annotations? What are assertions? why they are used why not if-else?? what is normalization? what is QuickSort? what are Avl trees?
1821hello sir, i'm persuing my B.tech final year in textile chemistry and have a diploma in electronics and communication...interviewer ask why you should adopt textile chemistry from electronics and communication....please give me the best answer... thank you
1281write a programme to identify the biggest number from the given three numbers with out using of relational operators
1485I need to know the productivity of meason/labour/barbender/carpenter while doing work like Shuttering, reinforcement steel, brick work, earth work?
1 9639Sir we have 12.5 MVA(110/11KV) transformer (Y-Y) connected,which tripped showing earth fault,when we charged transformer it stood OK ,but on connecting 11 KV feeders it tripped showing earth fault.our service engineers found that the B phase and R phase phase connecting to neutral broken from HV OLTC(on load tap changer),and R phase and Neutral is ok.Dissolved gas analysis shows that accetline content is high,tan delta value is 12.My dout is it is an internal fault of transformer,why REF or diffrential relay is not acted?
1 4173
What is Critical path in Ms-Project ?
If two shafts used for transfer of drive are inclined to each other, then a) Slip joint is used b) Flange coupling is used c) Universal joint is used d) None of the above
In electronic assembling industry(SMT), what are all the interview questions they will ask while recruiting?
How to convert 2 phase to 3 phase electricpower in induction moter?
What are the causes of troubles in boiler during operations?
What is the temperature PROFILE OF A FLUID W. R. T. Distance from a sphere to which it is IN CONTACT which is at constant temp.?
why the NGR (neutral grounding resistor) always OFF during DG off?
What do you understand by aerodynamics/performance analysis?
what are software interrupts present in 8051 Microcontroller? Only Software interrupts//////
Explain me what is seam allowance?
what is the maximum delay gnerated by 555timer and why?
Can you share a specific case where you used lean techniques to reduce waste and increase value in a manufacturing process?
what about the power of wattmeter at starting and loding?
In CTs tan delta point should be earthed , what is the reason behind it?
How can you estimate a gas flow based on two pressure measurements?