Can any1 say how this prog logic works... i am weak in thread concept...pls explain step by step
1 2735What are the effects to a distribution transformer rated 10Kv with ratio 10Kv/0.433Kv, 3phase 50hz for example but fed with power supply of 11Kv?
2 3509
What is the condition to be satisfied in the selection of l and c in a series inverter?
hi, i have completed my b.e. marine could u pls suggest me some job site for marine engineering?
how much st. steel is required for staging of concourse slab of a elevated metro station allowing through traffic .
What is the difference between scpc and mcpc?
telecom rf engineer
why desuperheater tubes are bend in shape
diameter of cable and core is doubled then the value of capacitance is
what is the difference between switchgear and circuit breakers and is there any difference between outdoor and indoor switchgear and circuit breakers , and how would you differentiate between switch yard and substation and grid station . thanks
if mineral admixture add into concrete then what is the differences between full cement concrete & fly ash added concrete of their SP. Gr.?and for the changes of SP. Gr. what is the changes in concrete
why can we use cosine wave instead of sine in ac supply as both have same rms vale and ripple factor
Why derivative controller is not used in control systems?
What are the reasons of removal of particles from effluent gas?
plz send me Bhel, Mahagenco, sbi previous exam paper for electrical engineer on my email-id kambali_smita@yahoo.co.in
can anyone can let me know in Eurotron Micro cal 2+ calibrator in milli amps source mode we are not able to get 20 milli amps output it only produces 1.52 milli amps out, but display shows increase in milli amps , and err6 displays, let me know how to remove the err 6.
What is the difference between emulator and simulator?