Interested to Buy Any Domain ? << Click Here >> for more details...
i am working in thermal power plant . if temperature transmitter is not showing reading in dcs then how can we rectify the problem?
TATA,
8 16331Post New Instrumentation Questions
what is compensation? temprature & pressure
What is defferent betwen ESP &PCP PUMP .HOW IT IS WORK?
I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.
Calibration of controller (pneumatic)
HOW CREATED LP & HP PRESURES IN DRUM FOR DRUM LEVEL MEASUREMENT!
What are the type of bonnets in the control valves?
what is Best Among SINK Or SOURCE Type Design In Digital Signal, Either Iput Or Output? WHY?Can any one..
Actual using of tube bender to bend 2 opposite 90 deg at correct measurement center to center of tubing.
what is the responsibility of an instrument commissioning supervisor
why we are not using the turbine flow meter in the steam service?
how can i calibrate the temperatuture gauge used by temperature bath(dry block) i mean step by step procedure?
i have steam drum height 1000mm. and i want to placed the transmitter below the tap.how i calculate.
What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.
What care will you take in the installation of control valves,SCADA,DCS and FOC in Oil and Gas Project?
how to measure draft pressure in transmitter pl. give its single line digram
