How will you select suitable Instrument for Process line/Tank/Vessel?

Categories >> Engineering >> Instrumentation
Suggest New Category

How will you select suitable Instrument for Process
line/Tank/Vessel?

Question Posted / mons

5 Answers
7820 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

How will you select suitable Instrument for Process line/Tank/Vessel?..

Answer / jacob m.i

Depended up on process cofiguration.

Is This Answer Correct ?

9 Yes

3 No

How will you select suitable Instrument for Process line/Tank/Vessel?..

Answer / guest

selection Depending upon process material and process variables

Is This Answer Correct ?

7 Yes

3 No

How will you select suitable Instrument for Process line/Tank/Vessel?..

Answer / rohit

firstly identify the content of process after that compare
with instrument's specification.then select them on the
basis of high effiency collected at o/p.

Is This Answer Correct ?

2 Yes

0 No

How will you select suitable Instrument for Process line/Tank/Vessel?..

Answer / tamilselvan

Depending upon process variables and process material type (liquid or gas).

Is This Answer Correct ?

0 Yes

0 No

How will you select suitable Instrument for Process line/Tank/Vessel?..

Answer / rabee

safety is first then process variables and its range with
high effiency and reliability,last thinking in the cost.

Is This Answer Correct ?

0 Yes

2 No

Post New Answer

More Instrumentation Interview Questions

what is the difference between plc and pc?

5 Answers ADI, NFCL, Wipro,

.how does CSADA systems display the process variable value?

2 Answers Empower,

What is seeback effect?

3 Answers

What happen if we install my pressure transmitter below the elevation of pipe in natural gas service?

0 Answers

pls provide me syllabus and old question paper of instrumentation engineering for GET(JSPL)

0 Answers

Why trim span ? How?

0 Answers

(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.

0 Answers ADMA OPCO,

what is Pre- commissioning.

5 Answers Saipem, Takreer,

on interface level transmitter model(RTG3302-EMERSON) What is threshold valve how can we select correct threshold value T1,T2,T3,T4 When interface water & hydro carbon

0 Answers

Please can anybody tell me the step by step procedure for calibrating the Pr,Lvl,Fl,Temp transmitter on process?

1 Answers

WHAT IS TMXT IN TEMPERATURE FOUNDATION FIELDBUS.

0 Answers

what is meant by nuclear collector?

0 Answers

For more Instrumentation Interview Questions Click Here