Interested to Buy Any Domain ? << Click Here >> for more details...
How will you select suitable Instrument for Process
line/Tank/Vessel?
- 5 Answers
- 7807 Views
- I also Faced
- E-Mail Answers
Answer Posted / rabee
safety is first then process variables and its range with
high effiency and reliability,last thinking in the cost.
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
Full form of KKS when use DCS.
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
what is piezoelectric transducer?give an example in power plant n state its principle?
Draw symbols of the following :
How can measure flow in oil line?which type of transmitter is generally used?
How does temperature bath work? How does coil gets heated only by applying some current?
where proximity sensor installed on tank in loading arm application
i want to know the interview format fot gail, instrumentation. pls answer me in habib.sami1003@gmail.com
Instrumentation symbols interpration, P& ID, Logic diagram analysis, Electrical drawing analysis.
Why all the drains(Gland sealing,ESV,Casing inlet etc) are directly connected to the flash tank instead of hotwell of the condensor in the power plant? My Email Id:naba02222@gmail.com
What is instrumentation measurement?
Which type of diagphram use in costic line,DM water line,natural gas line,oil line?
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
Why the ammonia and Nitric Acid level indicators is with millimeter ? and What is the conversion form millimeters that level indicator indicate to weight ?
installation process of orifice,a question asked for confusion creation in interview by BARC 1.if orifice is tightly fitted with pipe ,it will act like venturi 2.if orifice is left hanging in between liquid it will not create the pressure difference exactly,
