How will you select suitable Instrument for Process
line/Tank/Vessel?
- 5 Answers
- 6214 Views
- I also Faced
- E-Mail Answers
Answer Posted / rohit
firstly identify the content of process after that compare
with instrument's specification.then select them on the
basis of high effiency collected at o/p.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Why boiler chimney area oxyden sensor fixing?
what is moisture probe? What are there types? What is there working principle and how they works? guys this is one of technical question I had ask in interview. If you know its answer please let me know. The interviewers were more interested in microwave moisture probe, so if you find its any link please just forward me on my mail id.avinash1200@gmail.com Thanks in advance.
what is the calibration procedure for transweigh make weigh feeder?
Is it ok, to use non-contact type Radar type LT, on a tank that is half circular from the bottom side? If yes the, isn't the waves gonna bent in other directions?
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
what is use of communication wire in multipare cable(oil and gas field), why this communication wire not used in single pair cable?
What is defferent betwen ESP &PCP PUMP .HOW IT IS WORK?
how to rectify the poor signal strength in utrasonic digtial flow meter ,model:ge digital xce868i
what different types of problems do occur while doing instrumentation commisioning and how to solve them? please explain in detail
Describe the typical instrumentation used in monitoring the performance of a shell and tube heat exchanger.
What is compensation for flow ? Why we use compensation ? What are the factors of different compensation ? We not use then what problems may happen ?
Which type of pressure can be measured by primary elements?
what is metal of piston ring
How to calibrate displacer type level transmitter (chemtrol make )for level measurement in hotwell , LP & HP heater ?
Decibel.
