Answer / rahul

may be it works on electromagnetic induction....i think so

Answer / pradeep

servo motor operates on the principle of nonlinear negative
feedback.It only works in closed loop.That means feedback
is necessary for its operation.Feedback is taken by
encoders,generally resolvers.It gives position feedback and
speed feedback which separates it from simple motors.It has
high torque.If there willnot be any position feedback then
it cannotbe a sevo motor.

Answer / vishal kumar

Servo motor works on the principle of Electromagnetic Induction.

There are 3 pins or terminal are present.

1. Supply voltage
2. ground
3. Error signal

It is a close loop mechanism.

It always compares the error signal and the reference signal .

And the shaft will rotate only when the voltage is applied to it and it gets stop after removal of supply voltage.

Answer / rahul

servomotors are used to control the mechanical position.

Answer / monu singhmar

Servo motor works like a servant, when u give any command to
servo pack through pulse encoder it can processed. IT IS A
CLOSED LOOP SYSTEM IN WHICH FEEDBACK IS TAKEN VIA
PULSECODER.

Answer / shivangi

basically it works on farraday's 2nd law.

Answer / sandy

servomechanism is a feedback closed loop control device in
which negative feedback is applied to the input through the
feedback element in this system output position is
unchanged(constant).

Answer / s.palanisamy

it works in the principle of faradays law of elecromacnetic induction .its out put shaft can be turned by giving pulse width to the servomotor and its position can be compared by using encoder,then compare input and feedback an error signal is send to the servo motor to control the possision.by changing pulse width we can change the possision.

Answer / naveen mm

it works on the principle that ferro magnetic movable part
alligns itself along the direction of least reiuctance.

Answer / subrahmanyam

I think this will acts like a transformer when the voltage
is high it will acts as stepdown Tr & if voltage is low it
will acts as stepup Tr.

this was mostly used in Voltage stabilizers & for online
Tap changing facility in Transformers

Why LT cables are not sized based on short circuit capacity.

3 Answers  

how we select the mva rating of the circuit breakers?

1 Answers  

How to calculate Grid rotor resistance(GRR) losses in slip ring induction motor?

0 Answers  

6. A DC AMMETER HAS R=0.1 OHM & CURRENT RANGE IS 0-100 A IF THE RANGE IS TO BE EXTENDED TO 0-500 A THEN METER REQUIRES SHUNT RESISTANCE OF ..........

2 Answers   SSC,

Where the excitation is given either stator or rotor in actually in power plants?

13 Answers  

what is the difference between the megger and multimeter operation ?

3 Answers  

How to calculate mf when meter equipment and meter are connected

0 Answers  

sigal phase supply is 230 v ac two phase supply is 415 v ac then why three phase supply having supply is 415 v ac why not 690v ac

2 Answers  

What is the type of feedback used in an op- amp schmitt trigger?

0 Answers  

what is mean by busbar and what is the difference between busbar,transmissionline,feeder,distribution line

0 Answers  

critical losses of transformer

3 Answers   EEEC,

In transformer which temp should be less oil temp are winding temp?

7 Answers   TCS,