6. A DC AMMETER HAS R=0.1 OHM & CURRENT RANGE IS 0-100 A IF
THE RANGE IS TO BE EXTENDED TO 0-500 A THEN METER REQUIRES
SHUNT RESISTANCE OF ..........
Answers were Sorted based on User's Feedback
Answer / viral takodia
0.020 ohms generated same 1 v at measuring side. we have to just multiply the pointer value with 5.
Is This Answer Correct ? | 2 Yes | 0 No |
What is done to avoid interference of high frequency transmission lines with communication lines??
In our factory there is one no. of Series trip HT 6KV OCB. 1. Is it possible to measure CT out put current by 440V Clamp meter? The measurement is required for knowing the exact value of current in CT secondary to set up protection for transformers. 2. plase forward the single line diagram of AMF panel?
if a 3 phase induction stator has charactristic plate and have on winding inside.with the calculation of plate or dimenssion of core how one can desinge rewinding drawing.
wat system call?
power transmission pole used one support , that only for support or earthing
how to calculate 'In'in a system?
What is the basic difference among Circuit breaker,Contractor and Isolator? Are they different names of same device/equipment?
what is buscoupler adopter panel????
What Is Sampling?
0 Answers Mahatma Gandhi University,
What is mean by PID controller? And what is its Long form?
Why Drives are used to run AC motors?
what is meant by line voltage and phase voltage in a three phase transformer?