Dear all,recently in our plant we installed a conveyor for this the motor ratings are 5 hp and Amps 7.39.Due to on urgent starting of conveyor we fix the DOL starter with range of 9-15 amps.give me suggestion regarding on this issue
Answer / sandip
Use VFD and connect output choke if cable length is greater than 50 meter
Is This Answer Correct ? | 0 Yes | 0 No |
why there is a fault occurs, if a phase wire touches ground.. and the fault not occurs when we connect a bulb between phase and ground..??
How cmd is calculated in case of energy neters
How many size of cable required for a 300m long and 30kw inductive lode
what is the maximum Load capasity in LV-Panel,MDB,SMDB & Final DB'S in Electrical disribution system?
I have a 25kVA three phase transformer on our property. Will this transformer be large enough to run a large home with swimming pool, spa, 2 off full size reverse cycle air conditioners to service a 100 square house (10,000 square feet or 930 square metres)and the general power consumption of this house without upgrading to a 63kVA transformer.
we have 1000 litre water tank,it located at 25m hight from ground level,the water level on 10m below from ground level.for fill the tank within 1 hour,how much of motor rating(HP) want to select?
What will hapen if we run generator below 47.6hz frequency?
we have a 2.5hp Starite electric motor water pump,the elec motor burned out,we need to replace starting capacitor(old capacitor specs erased),what microfarad rating capacitor do we need? 110-125V
how calculate the current faut level
what is the difference between potential Transformers and capacitive voltage transfoemers and where it is used?
can you any one give exact mathematical relation between AC current and DC current?
Is it possible to connect a safety device in to parallel?