Answer / govardhan

if u didn't got the continuity,
1. make sure about the perol from field to jb ,jb to field
2. make sure about the core number
3. make sure about the terminals are properly terminated or not?

what would be the minimum flow rate that we can measure on rotameter..?

0 Answers   TATA,

---

Please explain for RS 485 & RS 232 communication

1 Answers   Honeywell,

---

How to get Cv of control valve having following parameter ,i.e inlet pressure 4.5kg/cm2 outlet pressure 1 kg/cm2 specific gravity 0.808

3 Answers  

---

How can one improve linearity of an RTD based temperature measurement system?

2 Answers   Honeywell,

---

Condensation within a sight glass? Would you expect there to be more problems when using a sight glass if there is condensation on the inside or the outside of the glass, and why?

1 Answers  

---

What is minimum distance between three thermocouples (2oo3) mounted on same pipe line (20")? Technically accepted by stright line mounted or circler mounted?

1 Answers  

---

how will you check torque value during Factory acceptance Test for control valve/ESD ON/OFF VALE how will you confirm this torque value is being correct, Which document will you be refer.

0 Answers  

---

if the t/c o/p is 4-20mv then how plc recognize it because we are dealing with the 4-20ma in the plc ????????????????

7 Answers  

---

define SIMULATION a and what is the need of it

3 Answers   Siemens,

---

How it the difference between force balance system and dispalacement balance system?

0 Answers  

---

What is SCR?

9 Answers  

---

what is the full form of psig.

8 Answers  

---