Answer / mohammad iftikhar

firstly u need to convert the following parametrs
1- conver inlet pressure into PSIG, your outlet pressure
2- you need to know what is your temperature max & min
3- you must know your flow rate
4- diffrential pressure
5- nominal pize size
6- sizing for ....mean for which fluid

Answer / marankrapu

Roughly the Cv is Flow rate (q) divided by square root of
Delta P over fluid sg

Answer / abhiic2008

please provide the calculation form for this

what is the usage of QDV & VOLUME BOOSTER.

2 Answers   ADMA OPCO,

---

What is procedure on mmwc in to tph

2 Answers  

---

Which type of pressure can be measured by these elements?

0 Answers  

---

which is the best type to measure level of a Tank(water). Displacer or Differential Pressure method?

2 Answers  

---

please tell me five types of fault of control valve and positioners?please

1 Answers  

---

Q- Control problem are mainly classified in _____ types. a-)4 b-)3 c-)6 d-)nono of these Few of them i know is 1- regulator type problem (eg- Air conditioner) 2- tracking problem (eg missile trcking problem) 3- sybernatics 4- optimal control problem

0 Answers   Sail,

---

1 bar is equal to how many pound per square inch(psi)?

14 Answers   Essar,

---

in any transimitter (flow/level) there are three terminals for supply& test (+,-,+)in two wire,24VDC given to Tx.,but how 4-20 ma signal travels thru same wire (as it is for 24VDC input supply)?

1 Answers   Jindal, UltraTech,

---

What is the difference between HMI and Scada?

4 Answers   Schneider,

---

use of split range ? where it is used ? in which control loop it is used ?

0 Answers  

---

what is a device net.

1 Answers  

---

Tyes of interface level measurement and how to use that technique for interface level measurement,

0 Answers  

---