Answer / praveen kumar paulraj

PLC based process automation panels. which is nothing but
control system which uses PLC .the same process can be
controlled by other control systems, but, why by PLC because
in PLC we can write the logic by ladder diagrams,so that the
electrical engineer can understand the logic and, he can
easily re-program the logic in side the plc because the
ladder logic is just like wiring diagram.

Answer / prvn

the control system which uses PLC is called PLC Based
control system .why PLC because we write ladder logic in plc
. it is invented for electrical engineers ladder logic
diagram is as same as relay logic diagram so they can
understand the logic inside the PLC. we can control system
also other means

Can we install and run MCCB suitable for 440v 3Phase 4wire system, on a 220V 3Phase 4Wire System.

3 Answers  

---

what is different between electrical ckt&electronic ckt

4 Answers   Ashok Leyland,

---

how much UPS neutral erath leakage current.

0 Answers   HP,

---

what is mean by tan-delta tap in the potential transformer??

2 Answers  

---

how can we find CT coil not working ?

7 Answers  

---

---

TELL ME, WHERE SHALL I GET BASIC ELECTRICAL ENGINEERING BOOKS IN INTERNET?IT SHOULD CONTAIN ALL DEFINITIONS?

0 Answers   TCS,

---

How to check op amp using multimeter

1 Answers  

---

how can we calculate fault current of a line in a 6 bus syatem if the faulted line is known?

1 Answers  

---

I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?

0 Answers  

---

what type of protection used below 132KV feeders

11 Answers   APTransco, Telecommunications, wbsedcl,

---

The capacity of the transformer is 20/25 MVA, Ratio is 132/11 KV, Vactor group YNyno. and impedance is 10.07%. As per the calculation the secondary current is 1312.2Amps. The maximum fault current the transformer should sustain is 13.030KA. How many times the transformer should sustain the maximum short circuit current of 13.030KA over a period up 1 Year. The transformer is repaired one & 10 Years old.

1 Answers  

---

when the flux enters into saturation mode then what will be the secondary voltage of the normal t/f?....high or low ? explain ...how?

1 Answers  

---