Answer Posted / praveen kumar paulraj
PLC based process automation panels. which is nothing but
control system which uses PLC .the same process can be
controlled by other control systems, but, why by PLC because
in PLC we can write the logic by ladder diagrams,so that the
electrical engineer can understand the logic and, he can
easily re-program the logic in side the plc because the
ladder logic is just like wiring diagram.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
Why compensation is necessary in feedback control system?
What is ramp signal?
how we design a pannel to start 10HP motor with the help of star delta starter?
What is the angle of inclination for the oil connection from transformer conservator to Bucholz relay and why?
HOW TO SELECT THE COPPER CABLE SIZES OF MOTORS,TRANSFORMERS?
What is cable tray, its type, and its support?
Vibromotor 252MV 1/4HP2P..what is mean by 252MV?
In HVDC LINE RECTIFIER CONTROL ON CONSTANT CURRENT AND INVERTER CONTROL CONSTANT EXITATION ANGLE CONTROL BUT HOW INVERTER CONTROL CONSTANT CURRENT?
what is the effect of change in supply frequency on load angle of synchronous motor,all other parameters remaining same?
What types of question are done for diploma students in aptitude test
What is 100% protection of generator? Why 100% is not used but 95% is generally used?
i m doing DEEE in part time,can i join regular cources in BE,,IF i join what the cources can i select like (civil,ece,IT) ,,kindly advice
what is negative d.c. voltage, why this voltage is used in base transciever station.
In CTs tan delta point should be earthed , what is the reason behind it?
does buccholz in a transformer use batteries
