Why PT burnts?
Answers were Sorted based on User's Feedback
Answer / hareesh k.s.
actually PT is step down the voltage in large margin for
eg.110KV/110V.ie secondary current is very lage in
comparison with primary such as 1000times.therefore if
there is short circuit in secondary terminals or open
circuit in primary pt will burnt.
Is This Answer Correct ? | 11 Yes | 1 No |
1) contamination of oil and insulation failure 2)lightning
stroke 3) over voltage4)over current and overheating
Is This Answer Correct ? | 1 Yes | 2 No |
all types of electrical quations
how to select the isolation tranformer for siemens 802dsl cnotroller
STATE WORKING OF SF6 C.B.?
In a carnot engine with an efficiency of 40%, the heat rejected to the sink at 27 C is 60 kJ, then the heat supplied in kJ to the engine by the sources is
do we use neutral grounding for resistive balanced load? if we use what happen?
What happens if the negative to earth voltage is greater than positive to earth voltage in the battery of substation?
what is the installation process for lifts
i want to know how to calculate the battery capacity based on the UPS . ex i want to run have one kva UPS Which should run 10 hours ? in that case how many batteries to be installed and what will be the AH Value .
Is it possible to connect a safety device in to parallel?
why the electrolyte level in lead acid battery is maintained 2.5 cms above electrodes?
What is mean CT Saturation? How to calculate?
what do you mean by power factor ? in new view