Answer / saurabh agarwal

Use of fly ash bricks is dangerous bocause of the following reasons:-
1. smoth surface doesnot stick plaster properly
2. brick when cut by machine for electric pipes, it transform into pieces
3. not a water absorber. a good and tough building needs plenty of water.
4. not so much difference in cost it we compaire it with good clay brick
5. sudden dammage in the wall will leads to a big hole.
i am saying which i felt while using this brick

If there is anyone who is using this brick will be facing this problems.

How many bricks required for 1 cu.m

7 Answers   Navayuga,

---

what is the minium content of cementous material per cu meter

2 Answers  

---

what"s the purpose of dry lean concrete(DLC)and where it"ll be use it?

5 Answers   Jaypee,

---

Differenciate between One way slab and two way slab

5 Answers  

---

A doubly reinforced concrete beam is 25 cm wide and 50cm deep to the centre of tension reinforcement. The centre of compression is steel is 5cm from the compression edge. The areas of the compression and the tension steel are 10.16cm2 and 12.56 cm2 if m=18 and the bending moment at the section is 7,000,000 N-cm. Calculate the stress in concrete and steel.

0 Answers  

---

what is mix design of sand cement and and aggrigate of M10 M20 M25..

2 Answers   MNC,

---

what is step foundation

2 Answers  

---

What is the coeffiencent Friction Angle between Steel and Ashphalt?

0 Answers  

---

What is difference between FE-415 and FE-500???

3 Answers   Enercon,

---

WHERE CAN I GET THE PREVIOUS QUESTION PAPERS OF APGENCO FOR THE THE POST OF Tr.ASSISTANT ENGINEER(CIVIL)

0 Answers   APGenco, Emaar, Madhucon,

---

What is the 162 in steel weight formula?

1 Answers   D H Patel,

---

If 40 backlogs are cleared m finally with 65 percent marks . Am I eligible to get visa to US

0 Answers  

---