Differenciate between One way slab and two way slab
Answers were Sorted based on User's Feedback
1 way slab; ratio of bigger dimension to smaller is greater
than 2. bending takes place along shorter span i. e shorter
dimension. load is taken by the 2 long walls only.
2 way slab: ratio is less than equal to 2. bending takes
place along both directions. loads is transferred through all
the 4 walls.
Is This Answer Correct ? | 53 Yes | 0 No |
if LY/LX < 2 = Two WAY SLAB
LY/LX > 2 =One Way slab
Is This Answer Correct ? | 7 Yes | 0 No |
Answer / udhaykumar
Ly/Lx > 2 ,is called one way slab..
In the slab, bending moment is more in shorter span..so, main rod is provided in the shorter direction.....
Ly/Lx < 2 , is called two way slab.. In the slab bending moment is more in both directions... so, main rod is provided
in both direction..
Is This Answer Correct ? | 1 Yes | 0 No |
Answer / mittal
plz explain in detail, that by which calculation we cum to
know it is one way or two way and by which formula?
Is This Answer Correct ? | 1 Yes | 1 No |
Answer / sanket bagade
LY/LX < 2 = Two WAY SLAB
LY/LX > 2 =One Way slab
where,
LY- Large Span
LX- Short Sapn
note- Main reinforcement is parallel to shorter side and distribution parallel to larger side
Is This Answer Correct ? | 1 Yes | 1 No |
what is the formula to find the diagonal shape stirrups?
Wat are the elements consider in the shuttering load design calculation
How many Steel used in 1 cum tower foundation
What are causes of cracks in outside plaster of a building and how we prevent it during constructions?
how much quantity of sand,cement,reqired for 100sqft of wall construction. And how much quantity required for plastring
1 Answers Jade Software, NSP, TCS,
for columns reinforcement the lap length is not provided then how to rebar the rods then how rebar should be lapped
4 Answers Nagarjuna Construction,
what is the difference between rcc pipe (pressure or non- pressure)and rcc hume pipe?
proportions of m10, m15, m20, m25, m30, m40, m45, m50, m60, m70, m75, m80 etc
which type of materials should be used for framed structure???
I want to know the relevant IS codes of practice which deals with different testings of cement-sand mortar (nominal mix)that is being normally used for brick work or plaster work in the construction work.
what is the crushing strength of good building stone
Process of pcc in wateredug