I need to connect a synchronous generator to the grid using
automatic synchronization and two circuit breakers (one for
synchronization, one for end connection to the grid), how to
determinate the required diameter of the cables?
No Answer is Posted For this Question
Be the First to Post Answer
how much excitation voltage required to generate 1mw power?
What is ht lt switchgear.
3 Answers Bhel, HBL Power Systems,
what is the function of bearing in dc mchine" and where it is placed
What is an Air COmpressor
What will happen if " not connecting the neutral point to ground of diesel generator output (380 V)", also if someone touched one phase without isolation from ground during the A/M condition what will happen to him?
Why DG self motor winding burnt out?
when a pure dc signal is sent through a moving iron meter, what will it read?? dc or rms?? when a variable dc signal is sent through a moving iron meter, what will it read?? dc or rms??
What is the Difference between Power Swing and Out of Step?
What is stray current in DC Traction?
in three 3.5 core aluminium ug cable. one cable is used for one phase by shrting R,Y and B wires and other 2 cables used for Y and b phases. balace 3 neutral wires are made common and connected to load. suddenly neutral current was more than line current what is the reason behind this?
how tan-delta test is performed?
what is fundamental difference between voltage and current