1. what type of winding of slip ring ac induction motor rotor and why. 2. how

1. what type of winding of slip ring ac induction motor
rotor and why. 2. how the heating element use in two phase
(415 volt)and what rating of element, you prefered.

Question Posted / vc

1 Answers
4880 Views
Simbhaoli Sugars, I also Faced
E-Mail Answers

1. what type of winding of slip ring ac induction motor rotor and why. 2. how the heating element ..

Answer / k.prakashchandra

Regular 3 phase windings for both stator and rotor.I don't
think heating element is provided .A low voltage is applied
to windings with help of a transformer so that a current
equal to or less than full load current is circulated to
warm up the windings .The voltage and capacity of this tr
depends on the rating of the motor.As the stator is normally
delta wound, one coil gets the full voltage and other two
50% each.As you press the start button ,the transformer gets
disconnected or you can switch it off beforehand.

Is This Answer Correct ?

2 Yes

1 No

Post New Answer

More Electrical Engineering Interview Questions

HOW DO YOU PROVE THE HIGH VOLTAGE CABLES OR BUSBAR IS DEAD EVEN AFTER IT IS DE ENERGISED

6 Answers

Explain (in simple ) - root mean square. whats its role in electrical fundamandal.where its used

0 Answers MRF, PPCL,

what is power factor in ac ckt ?

5 Answers

what is total power generation in tamilnadu What are the methods used powerfactor improved? which place DC transmission line usde?

5 Answers

What is Horan Gap Fuse? Where it is used?

1 Answers

In a Tap changing transformer where is the tap connected , is it connected in the primary side or it is connected in secondary side

8 Answers Indiabulls,

PLEASE SEND ME NTPC RELATED INFORMATION LIKE WHICH TOPICS HAV MORE SCOPE,BOOKS TO READ,CUT OFF...PLEASE.mail at thiru.1203@gmail.com

0 Answers

what do you mean by leading power factor & lagging power factor

13 Answers Suzlon,

how wud i know that whether i have to use unitized package substation or transformer?

1 Answers

Dear Friends, Need your help for connecting APFC panel, Quotation : I have 2 Noâ€™s 1000 KVA Transformers, both transformers are having separate APFC panels, ( Tr-1,400KVAR, TR-2,450 KVAR) Now I want to stop One transformer, present load is 650Amps, Max, So One transformer is enough, I have switched OFF TR-1, but PF is not maintaining properly, its 0.5, So now I want to connect TR-2 APFC also in TR-1 Loads, Can any one answer for my Quotation with drawing, how to connect TR-2 APFC panel in TR-1 Loads,

4 Answers L&T,

what material is the electrical housing wire made of? is there any difference for the telephone lines?

0 Answers

How i can calculate current of cable according to ares?

0 Answers Pharma,

For more Electrical Engineering Interview Questions Click Here