Why high Voltages come in multiple of 11, like 11 KV, 33KV,
66 KV, 132 KV etc.
Answers were Sorted based on User's Feedback
Answer / bhanu prakash
ac voltage of the system is measure in rms voltages,
so rms voltage= avg. voltage * form factor.
form factor of sinusoidal voltage is 1.11
since every avg. voltage multiplied by factor 1.11, high
voltage come in multiple of 11 only
Is This Answer Correct ? | 58 Yes | 11 No |
Answer / raju ravula
rmsvoltage/averagevoltage=form factor,in
transmisson,distibution systems voltages are rms only,the
form factir of sinesoidal wave is 1.11
Is This Answer Correct ? | 4 Yes | 4 No |
Answer / sandeepraj
i agree with ans 9
it not like multiple factors, they are just standerd values
Is This Answer Correct ? | 0 Yes | 0 No |
Answer / vinjam sasikumar
rms value = form factor * avg value
basically thee value of form factor is 1.11
so the ratings are in multiples of 11 kv
When the capacity increases, this is not true. It becomes 800kva, 1000kva
Is This Answer Correct ? | 0 Yes | 3 No |
Answer / sanju
yes i agree with the 1st answer. its almost the perfect answer
Is This Answer Correct ? | 0 Yes | 4 No |
Answer / susai
i agree with answer no.4. it is absolutely correct.
Is This Answer Correct ? | 1 Yes | 12 No |
Answer / guru
Its the british standard of making it in multiples of 11.
But as per US standard the HV voltages dont come in
multiples of 11
Is This Answer Correct ? | 4 Yes | 20 No |
Answer / sujeet kumar singh
i agreed with answer no 1 , but main reson is scientist Sir
G.V. volta invent 1.1 v battery so on behalf of sir volta
we multyply by 11 in volt.
Is This Answer Correct ? | 2 Yes | 28 No |
What are reasond for high wattage in single phase induction motors
What's ND relay & it's functions?
How to calculate the heat load for a electrical room
Sir we have 12.5 MVA(110/11KV) transformer (Y-Y) connected,which tripped showing earth fault,when we charged transformer it stood OK ,but on connecting 11 KV feeders it tripped showing earth fault.our service engineers found that the B phase and R phase phase connecting to neutral broken from HV OLTC(on load tap changer),and R phase and Neutral is ok.Dissolved gas analysis shows that accetline content is high,tan delta value is 12.My dout is it is an internal fault of transformer,why REF or diffrential relay is not acted?
why dc measurements are noted in mc whereas it is mi in ac measurements?
how can calculated the rating of the 11 KV transformer?
why transformer rating in KVA or MVA instead of KW n MW??
What is the power requirement of tamil nadu for one month?
What is the effect of using an underrated size cable to supply electrical power to a 3 phase ac electrical motor? What is the effect of using an overrated size cable for the same motor?
what is the main difference b/w contactor and relay
2 Answers Pace Pharmaceuticals,
The earth pin of some three pin plugs are seen split. why?
What is the safety of UPS?