Why high Voltages come in multiple of 11, like 11 KV, 33KV,
66 KV, 132 KV etc.
- 11 Answers
- 20822 Views
- I also Faced
- E-Mail Answers
Answer Posted / raju ravula
rmsvoltage/averagevoltage=form factor,in
transmisson,distibution systems voltages are rms only,the
form factir of sinesoidal wave is 1.11
| Is This Answer Correct ? | 4 Yes | 4 No |
Post New Answer View All Answers
Why insulation level follows this order? transformer < bus bar < circuit breaker & Isolator < transmission line.
Why strting torqe high in inducation motor?
how solar power plant energy meter multiplication factor
How to calculate the heat load for a electrical room
Why we are using only Dyn11 tranformer in distribution system but not using a Dyn1 in distributing system?why not and advantage and disadvantage in both
The sodium vapor lamp is not glows when it is connected a distance of 5 meters above from gearbox, why ?
A low wet bulb temperature indicates
any one please tell taht what type questions will be asked in BHEL interview, i am having interview on 24th Dec, please send this to mail pradeepsistam@yahoo.co.in
A 100W electric lamp is supplied from a 115V, 60HZ source. The peak instantaneous power dissipated in the lamp filament is
what is the VA(Volt-amphere)? define with calculation?
how we do Vector group ,magnetic balance and tap changer test in Transformer?
can i use the six sigma method which is used in management area, in state estimation of power systems?
what is booster? and how it is connected in a circuit?
how to calculte capacitor range for single phase induction motors??pls tel
How time response of the system is divided?
