Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379) How to select a cable size for particular load?
Amit Enterprises, Takasago Engineering, Techno Electric and Engineering,
1831How to Select a Transformer Rating ?
Tata Steel Limited, Techno Electric and Engineering, Vedanta,
3 6626Why inductor reverses its polarity why not capacitor while discharging evenif both are charge storing element?
1 3422
What should be the amps for a MV fuses for transformer 630kVA 20(10)/0.4 kV
why in a swquence network representation, the negetive sequence generated voltage is taken as zero?
What types of CMOS memories have you designed? What were their size? Speed? Configuration Process technology?
Why the feeding frequency to a microprocessor is twice the operating frequency?
What are the important ic technologies used?
i m electrical diploma holder i want to do plc $ Scada some body tell me which insitute is best for me near chandigarh
Wt is the function of reactive power? How it generates & consume though resultant is zero?
a) Difference between Ghol , Chimney & fly ash bricks b)Floor to floor height is 3m , rise=15cm , tread 20 cm , how to design staircase means steps landing
Can condensate control in a reboiler cause water hammer problems?
What is the advantage of on-off control?
Advantage of Aluminum form work in terms of activities can be skip and cost too
Why we use Electrical energy rather than any other type of energy, mostly? Explain behavior of open secondary CT and short circuited secondary PT in energized condition?
what happens when dc generator coupled with cycle shaft.also explain what happens when its loaded
what is meant by star/delta voltages as 440/220 in a 3 phase induction motor, and why it should be connected on STAR IN 3 PHASE SUPPLY
what are factors to be consider to design a HT & LT motor?