Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379) We have 800KW motor operating at 6600Volt,50 Hz supply.During 1st startup it tripped on overcurrent trip.It's FLA is 88 Amps.The K factor of Thermal overloaaad was set on .94 initially.then we set at 0.97 and then it started fine.i dont understand why it tripped first?What are the protections which comes in picture during starting ?
6 9828Comparative difference between 33Kv & 66KV for transmitting the load of 7 MW at a distance of 34 Km.
NHPC,
6 15712
What are the different ways in which solids can be blended?
what is Retainer?
i have chines vehicle Grand Tiger now its AC compressor become jam what should i do i have not found new in market
The screw thread commonly used for transmission of motion is one of the following types of threads
dear sir i m anshul kumar from dehradun i want to last five year railway chandigarh and allahabd entrance exam papers pls send it on my id my id is anshuldhiman83@gmail.com or anshuldhiman@rediffmail.com i shall be very greatful to u thank u
What parameters to be reported when we send lubricating oil for shore analysis?
What is CCM in Electrical ? where can we use this material?
previous year paper of ntpc bhel for degree in electrical enng
what is education Cess.
What is the release of lien?
How can maintain our H.T. motors used in cement plant. please send me procedure.
What is the use od d2?
what is the difference between single ratio, multiple core and multiple ratio, multiple core ? please explain.
Why are the uses 24vdc in industries
What are considerations taken into account while creating a piston head?