Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379) When we are calculating the heat load sheets,why we are not considering the heat developed from the blood in the human body.Also both men & women can't acess aircondition in same way..women feel too cool even at 22 degree,while men can overcome that.
DVC,
1937needed web address and its directory for objective type question with answer in electronics instrumentation paper.
3241Which transformer is suitable for 220/11 kV, 60 MVA, distribution , Y-Y or D-Y or Y-D, give comparison for the same.
3 10910
Why was the empire state building made of steel?
How can separation of chiral chemicals affect the chemical and/or pharmaceutical industries?
Suppose a new brick wall is being constructed,and the courses and not aligned horizontally,what negetives can it cause?
A generating system will have a total capacity of 300 MW. Find the probable forced outage when the capacity is supplied by two 150 MW units. The operating probability of all units is P=0.98 and forced outage probability rate Q =0.02 .
Why iso-octane is chosen as reference fuel for s.i. Engines and allotted 100 value for its octane number ?
Which rays are produced by cobalt-60 in industrial radiography ?
if 20mm aggregate is coming by weight 25 ton in a 10 wheeler hywa ,then what will be total volume of aggregate in cubic feet.
Define what is the significance of the arrow-head in the transistor symbol?
what does a k rating in a transformer means?
A rectangular beam section of 300 mm width and 500 mm effective depth is reinforced with 4 bars of 20 mm diameter, what shear reinforcement is required to resist 200 kN shear (use working stress method)?
High speed gear is obtained in the case of sliding mesh gear box when a) Motion is transferred through the clutch gear to lay shaft gear b) Main shaft is coupled to the clutch shaft c) Smallest gear on the lay shaft is engaged d) Largest gear on the lay shaft is engaged
Give four examples for footwear used by Romans.
Name some common problems associated with dense phase pneumatic conveying?
"how can we find the approximate quantity of materials using in a building or total Expenditure in percentage for rough estimate after known the construction area(sqm)".please if you know something about that please post the answer.
what is the differences between software engineering and other engineering disciplines.