Answer / jobby c johnson

in process control selection of a particular controller is
based on the application and what are process parameters that
you are going to measure.
based on the external conditions you have to design the data
acquisition system. some times the voltage level will not be
matching, so you requires a voltage translators(eg:).

there will be a process requirement saying that you need the
overall response of the system with in this much time, with
minimum error etc based on those parameters you have to tune
the controller parameters.

How will you measure surface temperature of SUN?

2 Answers   GAIL,

---

What happen if I install my pressure transmitter below the elevation of pipe in natural gas service?

0 Answers  

---

how to convert digital signal to analog signal in plc

1 Answers   UltraTech,

---

what is difference between Floating D.C.Voltage and Fixed D.C.Voltage?

2 Answers  

---

can you suggest good traning institute in instrumentation ? (in automation, or designing)

5 Answers  

---

How to calibrate capillary type level transmitter

0 Answers  

---

In RTU Panel we are having several Analogue & Digital Inputs /Outputs. We are recently facing some problems over Analog inputs , which are not updating properly (But Digital Input are updating normally) Can any one tell me from where the problem is creating , we have checked PLC CPU card, Analog Input card & we reconfigured ,But still the issue is there. Issue : 1. Sometimes Analog values are updating & sometimes not. 2. Analog values are not updating normally , showing some wrong Values 3. Total dead (0 value) Analog values are Level & flow measurement from the field instruments. (But in field the instruments are working normally & Displaying the values normally in local display unit) This problem we are facing in our Water Plant. If any one experienced this same problem or having any ideas related to our issue PLS send your valuable Answers/Replies...

6 Answers   L&T,

---

how can loop single 4-20 ma to two isolation amplifier? i mean i have two isolation amplifier with 4-20 ma input and 1-5 v output.can i done series connection ?

1 Answers  

---

pressure gauge measure static pressure or dynamic pressure?

3 Answers  

---

installation process of orifice,a question asked for confusion creation in interview by BARC 1.if orifice is tightly fitted with pipe ,it will act like venturi 2.if orifice is left hanging in between liquid it will not create the pressure difference exactly,

0 Answers   BARC,

---

What is the function of SMPS

2 Answers  

---

how u choose thermowell lenght n pnumatic C/v size?

0 Answers  

---