Answer / b.balaji rajgopal

orifice is nothing but a plate having hole at the centre
.when it is placed across a flow line a differential
pressure is created across the orifice due the diff. in the
dia of orifice and pipe line.this diff pressure is directly
proportional to the flow of the liquid.this differential
pressure is given to the differential pressure transmitter.

Answer / sandy

orifice is the flow element,placed in process line for
measurement of liquid or gas flow.
it is used to create differential pressure required for
measurement using dp transmitter.

Answer / joby

oriface plate can be used a primary sensing element for
differential pressure transmitters.basic principle is to
make restrictions in flow to obtain differential
pressure.which will be directly proposional to the flow
rate.

Answer / hvkkumar,mtech,instrumentation

orifice is variable restriction flow meter,it has two
tapings befor restriction and after restriction connect to
differntial manometer this pressure head is propotional to
the flow rate,it is based on bernuolis law and continutiy
equation.

Answer / visakh ctjv

orifice is a used as a primary element for flow
measurement.the differential pressure created by the
orifice is propotional to the flow rate.it is very cheap
and easy to install

Which boiler is use in power plant

1 Answers   Jindal,

how many types of spped sensors n vibration sensors?their basic principle n connection?

0 Answers   IOCL, ITC Infotech,

Draw symbols of the following :

0 Answers   CCIE,

Why we use 3-15 psi air for control valve input?

2 Answers  

why in vortex flow transmitter dcs range is configuring less than sensor range. eg (sensor range 500-25000 kg/hr and dcs range 0-24000 kg/hr).

1 Answers   Daelim,

what is reason behind boiler drum level transmitter range put -450 to 0 mmh2o.

1 Answers   JP Group,

What is cable size for intrenal wiring in DCS or PLC ,from any card to Terminal amd Why

2 Answers  

please send me hpcl placement papers

13 Answers   HPCL, L&T,

Explain PID controller tuning & any one method used for it.

1 Answers   L&T, Oil India,

If I installed wrong directions orifice plate then what showing value d.p transmitter?

2 Answers   Forbes, STS,

I have installed a RTD whose length is 2250mm(RTD stem length), but it's upper 200 -250mm is out of the reactor, and this upper 200mm stem is surrounded by atmospheric temp. And the lower portion i.e. 2000mm is in contact with the measuring fluid, then does the final measuring temp. Gonna change as the upper 200mm RTD stem is out of reactor?

1 Answers   Process Control Technologies,

What is the logic a Transmitter control a Control Valve? How the signal going to the Control valve? What are systems/Panels/cables/signal used to control valve from Transmitter?

3 Answers