wht is meant by sh6

Answers were Sorted based on User's Feedback



wht is meant by sh6..

Answer / beer mohamed

thats not SH6 That is Sf6 ,this is a gas sulfur hexa
floride this is used as a insulating medium for higher
rating breakers this is used as a insulating medium,arc
quenching purpose

Is This Answer Correct ?    18 Yes 0 No

wht is meant by sh6..

Answer / girish sail

thats not sh6 that is sf6 , this is sulfer hexaflorid
gas ,it is highly electronigativ ,it absorb free
electron,and so it used arc quanching medium in sf6 C.B.

Is This Answer Correct ?    1 Yes 0 No

Post New Answer

More Electrical Engineering Interview Questions

Why indicate only 440V to 3-phase supply.

4 Answers  


In DC while we mention the voltage we are using -48V but in case of AC we mention only 230V not -230V, why we using -48V not 48V

2 Answers  


Dear sirs, pls check this 4-20ma to RS485 module datasheet,pls guve me some suggestions. http://www.szsunyuan.com/sy/pro_more.asp?Productid=539 Thanks. E-mail:yunianjiang99@gmail.com

0 Answers  


after syncnhronistion how generator speed controlled by grid

3 Answers  


A 3 phase motor operating off 415V system is developing 20Kw at an efficiency of 0.77 and power factor of 0.73. determine:- a)the line current. b)the phase current if winding are delta connected. c)the phase voltage if winding are star connected.

1 Answers  






In response to Mr Bikas. If fault current is 52 kA then what will be the CT specification

1 Answers  


What is corona? and what is the purpose of corona belt in substation ? why they connect these end of the buses ?

2 Answers  


Why use windmills is squirell cage generators?How to calculate the slip ?

2 Answers  


where HT & LT capacitor uses ?

2 Answers   NTPC,


How to select the rating of a CT used for REF protection. The rating can be of equal rating of Phase current or neutral current rating

2 Answers   UltraTech,


where we sense the fault from the transmission lines?any operation example for distance relay?rear panel connection for this relay?

1 Answers  


Is Neutral earthing necessary for single phase system or Genset? if yes or no then why?

1 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5084)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16631)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1094)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)