What happens if the capacitive reactance of a transmission line is very high?

Categories >> Engineering >> Electrical Engineering
Suggest New Category

What happens if the capacitive reactance of a transmission
line is very high?

Question Posted / n. sonowal

5 Answers
16036 Views
ABB, Power Grid, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

What happens if the capacitive reactance of a transmission line is very high?..

Answer / prashant singh

when capecitive reactance of transmission line is high then
more charging current will flow through line rhen losses
will increases. and due to capecitive effect reciving end
voltage high the sending end voltage. and voltage
distribution is goes unequal.

Is This Answer Correct ?

46 Yes

4 No

What happens if the capacitive reactance of a transmission line is very high?..

Answer / richa

when capecitive reactance oftransmission line is high then
voltage is high ta the receving end

Is This Answer Correct ?

20 Yes

2 No

What happens if the capacitive reactance of a transmission line is very high?..

Answer / akshay dhar

This effect is prmarily known as Ferranti effect & due to which the receiving end voltage will be greater than the sending end voltage (abt 5-10% of Vs)

Is This Answer Correct ?

9 Yes

0 No

What happens if the capacitive reactance of a transmission line is very high?..

Answer / subhani

when capecitive reactance oftransmission line is high then
the power factor of the system will increase.sometimes it
may lead to ferranti effect also...

Is This Answer Correct ?

6 Yes

0 No

What happens if the capacitive reactance of a transmission line is very high?..

Answer / abhishek kunwar

when capacitive reactance of transmission line high then
high charging current will flow through line.due to leading
effect losses are increase.and this will inject the voltage
from receiving end and at receiving end voltage level increase.

Is This Answer Correct ?

1 Yes

2 No

Post New Answer

More Electrical Engineering Interview Questions

The initial current is very large at the time of starting for almost all DC motors. SO WE USE STARTER FOR A SAFE STARTING but at our homes we don’t see any starters in our coolers, motors.WHY DON’T WE NEED STARTERS FOR THESE APPLIANCES?

1 Answers

What should be the minimum depth of ground laid 66 kv ht cable?

3 Answers L&T,

why slipring motor , at full speed run as squirrel cage motor?

1 Answers

what is the control circuit for operating the clean room air shower

1 Answers L&T,

why corona ring is used in out door switchyard lightning arrestor

3 Answers

in an ac series circuit there are 30 bulbs are connected in a serial set.what will happen if one bulb is fused and we removed the bulb and reconnect with the remaining bulbs? (29 bulbs). will the brightness of other bulbs increase or not?

3 Answers

WHAT IS INERTIA,AND WAT IS TORQUE.

0 Answers

What is your acheivements

1 Answers

Why we are getting low voltage in star connection?

2 Answers

How the CT and PT ratings are calculated

5 Answers

why we take transformer reading in kva

6 Answers

In aerodynamic turbines which element is NOT there a.stator b.compressor c. Fuel intake system d.fans

1 Answers

For more Electrical Engineering Interview Questions Click Here