Answer / bunny

DP stands for differential pressure.i.e,we will have a high
pressure and a low pressure.DP=HP-LP.The idea is we will
create a differential pressure in the flow line(by using a
orifice plate,for example) were which the flow has to be
measured and will measure this DP which is proportional to
flow.For that,2 pressure taping will be taken(for HP &
LP)and it is connected to the the HP & LP connection slot of
the DP transmitter through a manifold valve.The DP
transmitter will convert these DP signal to (4-20)mA range
and send to the controller.

why vortex flow meters and electro magnet flow meters are used in water treatment plants

1 Answers   Elite Construction,

---

if we open the inlet of an air regulator ,how it will affect the out put of regulator? (out put of regulator is using to operate an on-off valve.it is an air to open valve,and valve is in open position.my doubt is air regulator will hold the valve in open or not,if there is no consumption or leak in regulator out put side ,we only loose the input pressure.)

4 Answers   Asian Paints,

---

what is modbus & what signals are taken through it

2 Answers  

---

wht is dcs architecture ? can u give example?

3 Answers  

---

What is the different between ESD & PLC.

1 Answers  

---

Calibration of controller (pneumatic)

0 Answers   CCIE,

---

What is the cascade control

0 Answers  

---

how can we calibrate the differential pressure transmitter by using HART communicator

8 Answers   Hindalco,

---

How can test or measure the probe and extension cable to identify if the problem at the probe or cable or at the driver it self? (pleast notify the measuring method)

0 Answers  

---

what is difference between positioner and position transmitter in control valve

2 Answers  

---

what is bms?

4 Answers   Emco,

---

How does temperature bath work? How does coil gets heated only by applying some current?

0 Answers   Process Control Technologies,

---