In zero voltage we can pass supply to our body means we cant get shock its tru

In zero voltage we can pass supply to our body means we
cant get shock its true ? how we can do it ?

Question Posted / kumar

4 Answers
6424 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

In zero voltage we can pass supply to our body means we cant get shock its true ? how we can do it..

Answer / anil kumar gautam

current always flow from higher potential to lower
potential.zero potential means our body touching the
electric wire ,both are at same potential.until there is a
flow of current through our body,we cant get shock.

Is This Answer Correct ?

12 Yes

0 No

In zero voltage we can pass supply to our body means we cant get shock its true ? how we can do it..

Answer / kumar

Mr.Anil thanks I can get your answer .but how we can get
it .please explain .thank u

Is This Answer Correct ?

0 Yes

0 No

In zero voltage we can pass supply to our body means we cant get shock its true ? how we can do it..

Answer / sree

Not true.
To feel shock min. 30 Volts (RMS) & 45 Volts (Max) is
required.

Is This Answer Correct ?

1 Yes

1 No

In zero voltage we can pass supply to our body means we cant get shock its true ? how we can do it..

Answer / rajagopal

Can use variyact Transformer it is used for 0 to whatour
you want raise and reduce

Is This Answer Correct ?

1 Yes

4 No

Post New Answer

More Electrical Engineering Interview Questions

An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm

0 Answers

WHAT IS DIFFRENCE BETWEEN 3 PHASHE AND 1 PHASHE

6 Answers Reliance,

Swg formulae

0 Answers Bokaro Steel,

Why the dc voltage drop during starting of emergency lube oil pump? The Voltage drop from 135kv to 125 kv for one min. before re-establish to 135kv?

0 Answers

if flux and load static in dc motor and supply voltage increases 20% then what happened in speed

0 Answers

What is kvar?

0 Answers

IF TVM OF TRANSFORMER SHOWS POWER FACTOR ON 33 KV SIDE AS 0.97 LAGGING AND ON 132 KV SIDE IS 0.75 LEADING.IS THIS CORRECT.WHERE IS PROBLEM.

0 Answers

Any one can explain if there is any harm from humming noise heard from air circuit breaker : we have 415 switch board having two incomers from transformers 3.3KV/415V , when bus coupler closed, and open one ACB incomer to work in one of the transformers, the current started hunting around 50 Amps, and heard humming noise from the air circuit breaker, although the load current was only 1200 amps while the ACB capacity is 2500 Amps, and the transformer 1600 KVA. The same didn't happen when taken the other transformer offline. Why this humming noise and current fluctuation? is there any implication or danger, bearing in mind that we just returned everything back to normal and stopped the maintenance of the transformer. Shall we go ahead and ignore this noise?

6 Answers

If we tell 60 sq.mm. 3-1/2 core cable,then what does it mean ? 1) Each core section in the whole cable is of 60 sq. mm. 2) The whole cable is of 60 sq. mm. which is sub-divided into 3-1/2 core.

3 Answers Cura HealthCare,

What is the important precuations need tocarried out while working with Electrolite in Battery PM?

0 Answers

what is the meaning of the parameters labeled on the surge arrestor like 150/20 ???

3 Answers

What is ferrite affects and what is disadvantage of ferrite affects.

1 Answers

For more Electrical Engineering Interview Questions Click Here