HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH
CONTAINS 2*1MVA TRANSFORMERS,LT-SWITCH
BOARD,MLDB,ACB,BUSBAR,ETC,......?
No Answer is Posted For this Question
Be the First to Post Answer
what is the criterion for selecting vector group of Transformers ? i mean how to decide vector group of Generator transformer, substation trasformer and transformer at consumer end
why do transformer humm ??????????
why we are called the 4-20ma transducer,not 0-20 ma transducer??
whta does the middle finger stands in flemings left hand rule
What is the male and female contactors.where is it's used and what is the deferent betweens
3phase lt motor winding how to checking with megger
What is LOTO?
What meant by XLPE cable
How much ampere rating on LT side of distribution transformer and also on HT side of 200KVA transformer
what is rated current and operating current?
What is difference between slip rings and carbon burushes?
What is an isolation transformer?Why do we need isolate circuits?Where do we use them?
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)