how many types of grounding?
Answers were Sorted based on User's Feedback
Answer / abdar ali
There are two types of grounding:
1. Plate earthing
2. Pipe earthing
Is This Answer Correct ? | 16 Yes | 5 No |
two types of grounding 1 is system grounding 2)equipment
grounding.
Is This Answer Correct ? | 11 Yes | 10 No |
Answer / muhammad saleem
two types of grounding 1 is system grounding 2)equipment
grounding.
Ref:NEC Book Article 250 also saudi aramco following this
book.
Is This Answer Correct ? | 7 Yes | 7 No |
Answer / chandrashekar
Types of Earthing / Grounding
1.Plate ERthing
2.Pipe Earthing
3.Water tight Earthing
as i know
Is This Answer Correct ? | 10 Yes | 11 No |
Answer / arvind
it is of two types i.e on point grounding and two point groundings we prefer 2 points grounding
Is This Answer Correct ? | 1 Yes | 3 No |
Answer / baha al
There are three type of earthing:
1- TN-C-S earth and neutral combined in the supply network
but separated in customer installation.
2- TN-S earth and neutral run back separately to the
transformer neutral terminal.
3- TN-C earth and neutral are combined right throughout the
installation
Is This Answer Correct ? | 3 Yes | 7 No |
What is fault.?
2 Answers AngloGold Ashanti, MNC,
What is RMU, and what it's function?
assume we are put both df/dt and vector surge relay in same bus the df/dt relay setting is +5 hz an -5HZ. we want operat the vector surge relay before the df/dt how i calculate the setting of the vector surge relay.
why transformer does not obey ohm law?
What is the name of process In VFD frequency are increase then voltage increase & frequency decrease then voltage decrease?
physical identification of HT & LT panel
how much insulation resistance 11kv & 33kv under ground cable between earth to phase & phase to phase.
why AC voltage source are generate as 50 Hz ?
What are the advantages and disadvantages of oil filled transformers?
2 Answers Mercantile Marine Department, Studio College,
WHEN SINGLE PHASE SUPPLY AS 220V, WHY THE 3 PHASE- 4 WIRE MEASURED AS 440 VOLTS INSTEAD OF 660 VOLTS (220 VOLTS PER PHASE i.e 220x3 = 660 volts ).
Difference between field rheostat and armature rheostat.
25 kva 3 phase dg how many current will take per phase , plssssssss reply me