Answer / sidu_aee_kptcl

In Nov-09.

what can i do, if i want to carrier in design as i am electrical engg?

3 Answers  

---

at high temperature conductivity increases for conductor what will happen for long transmission when temperature is high?

1 Answers  

---

What happens if a +vely charged particle is placed in the centre of a room and assume that the north side wall is having magnetised with north polarity and south side wall is magnetised with south polarity. In which direction the particle will move

5 Answers   BSNL,

---

Why we are use 11KV / 22KV / 33KV / 66KV / 110KV / 230KV / 440KV this type of ratio. why cant we use other voltage ratio like 54KV / 99KV et.,

8 Answers   College School Exams Tests, Hino, ITC Infotech, Reliance, UPRVUNL,

---

for 1000kva transformer how kvar rating is need for this PFI plant. and how does it will calculate? and Apmpere rating of main cable connection?

6 Answers   Engineers India, GCC, KP, QPSL, Siemens,

---

what is the value of current as well as voltage upto which we will not feel shock and why?

3 Answers  

---

in a large three phase induction motors usually the value of full load slip is

1 Answers   PSEB,

---

i need list of swg(standard wire guage) or area of conductor v/s current carrying capacity of conductor copper & alluminium...

0 Answers  

---

Any one can explain if there is any harm from humming noise heard from air circuit breaker : we have 415 switch board having two incomers from transformers 3.3KV/415V , when bus coupler closed, and open one ACB incomer to work in one of the transformers, the current started hunting around 50 Amps, and heard humming noise from the air circuit breaker, although the load current was only 1200 amps while the ACB capacity is 2500 Amps, and the transformer 1600 KVA. The same didn't happen when taken the other transformer offline. Why this humming noise and current fluctuation? is there any implication or danger, bearing in mind that we just returned everything back to normal and stopped the maintenance of the transformer. Shall we go ahead and ignore this noise?

6 Answers  

---

In our plant we have installed new MCC with ELR and CBCT which is detecting some leakage current in the system but it leading to some confusion when to check that in which feeder which is drawing current we put off the whole panel itself but still CBCT detecting some leakage current so can anybody ans me , where i am going wrong or how to detect whether its actual leakage or CBCT malfunctioning.

0 Answers   Saint Gobain,

---

how one can know the charging time, discharging time of a 12 VDC battery ? If i have a battery of 12 VDC , 4.0 AH , how long will it take to charge from a charger (power supply) of input 220 V , Output 15 V and output current of 3000 mA and how long will it take to discharge whether using or not ? How much backup will it give ?

1 Answers   ONGC,

---

Why does the speed regulating system adopting I controller have no steady-state error? In this single closed-loop speed regulating system, when the input of the I controller Un=0, what is the output voltage of the regulator? What factors do the output voltage depend on?

0 Answers   Sterling Wilson,

---