why we are going for coding in communication signals?

Categories >> Engineering >> Electronics Communications
Suggest New Category

Question Posted / amirtha

6 Answers
7681 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

why we are going for coding in communication signals?..

Answer / chethan

To improve the range of communication by preventing the
signal getting distorted. and for providing security.

Is This Answer Correct ?

6 Yes

1 No

why we are going for coding in communication signals?..

Answer / lakkup

it is done so that the original information is converted to
a code ,so during transmission there is no possibility of
retrieving the original information i.e.,security based and
at the receiver side the code is converted to original
information

Is This Answer Correct ?

4 Yes

0 No

why we are going for coding in communication signals?..

Answer / asrar

For digital transmission we need to code the signal.further
to provide high fidelity for long transmission and reduce
the distortion to minimum levels

Is This Answer Correct ?

3 Yes

2 No

why we are going for coding in communication signals?..

Answer / sudeep

it is to reduce the channel errors in the transmission, it
will reduce the BER,

Is This Answer Correct ?

1 Yes

0 No

why we are going for coding in communication signals?..

Answer / karan bhardwaj

It Is Done So Becuse Due To Codding We Secure The Data And
Only The perticular Receiver Who Know The Code Of Sender
Can Receive The Code By Decoding The Message. This is
Mainly Used In The Army Purposes Where We Need Very Much
Security.

Is This Answer Correct ?

0 Yes

0 No

why we are going for coding in communication signals?..

Answer / anamika pandey

We are moving towards coding so as to:-
1)Use same same frequency and time repetedly by changing
coding technique.
2)For security purpose.
3)To minimize distortion of signal,crosstalk etc.
4)To increase capacity.

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Electronics Communications Interview Questions

What are the dc,ac characteristics of op-amp?

0 Answers

how to convert the plain text into cipher text

1 Answers

modulation means

11 Answers Assurgent,

what type of question can be asked in the interview for the post of the technical officer?

1 Answers NASA,

what is bal

1 Answers TCS,

what are half adders n full adders?

1 Answers

WHY FM IS NOT USED FOR VIDEO SIGNALS

6 Answers BEL,

1. A bomber drops a bomb from an aircraft flying at 2000 km/hr. at an altitude of 7km. The speed at which the bomb will strike the earth would be

7 Answers Pakistan Atomic Energy Commission PAEC,

what is difference between esd grounding and electerical grounding.standared resistance value between esd grounding and electrical grounding (Plz. give reason also that why we keep this value.

2 Answers KJ, TATA, Wipro,

wat is difference b/w gateway and router

1 Answers

Explain why nand-nand realization is preferred over and-or realization?

0 Answers

wat should be the main steps for qualifying gate.

0 Answers

For more Electronics Communications Interview Questions Click Here