Answer / anjani

FM DEMODULATION RESULTS IN A RANGE OF FREQUECIES i.e
basically bandwidth required for FM is high, also the video
signals themselves hav a large BW therfore if video is FM
MODULATED THEN THE BW REQUIREMENT WILL BE VERY HIGH SO
VIDEO SIGNALS R NOT FM MODULATED

Answer / vinit92

when we are using fm for sending video signal then in fm
phase shifting will be happen and it can be easily seen by
the eyes in t.v and it requires a larger bw. amplitude
,colors,contrasts can be easily adjust in am so we are using
am in transmitting video signal and where as a fm is used in
audio signals........

Answer / sarada

video is a combination of frames and when dealing with
properties of frames the main one will be amplitude
(color,contrast,brightness) as one of the parameter.And
with audio signals we have to concentrate on frequeny (of
signals)

Answer / ravindar singh

1. Video signal exhibits a large bandwidth and significant
low-frequency content which suggests the use of VSB,

Answer / pratiksha

FM makes phase changes in signal that can be easily perceived by viewer as distortions, also BW requirements are more for FM hence AM is feasible

Answer / mukul pateriya

since bandwidth of video signals are
on the range of 4.5MHz .if it is modulelted
with FM .then bandwidth requirement will be more.
which should not be desire.
also video signals posses very low frequency component .
its reception needs very sharp cut off filter so VSB is
used.

What is the difference between binary code and bcd?

0 Answers  

Which oscillator is best for general purpose?

0 Answers  

When compared with other transducers measuring temperature, a four-lead platinum RTD 1. has better linearity over a wide operating range 2. has better accuracy and precision 3. has better stability at high temperature 4. is inexpensive Which of these are correct? Select one: a. 1,2 and 3 b. 2,3 and 4 c. 1,2 and 4 d. 1,3 and 4

1 Answers  

What is the Difference betn IBS & REPEATER?

0 Answers   Videocon,

hello sir, could u plz send me a sample placement paper for hpcl trainee engg exam..(electronics stream)...hoping to hear from u at the earliest. Thanking you.

0 Answers  

why we use zener diode in switching action

1 Answers  

AT WHICH VOLTAGE AN OP-AMP OPERATE

11 Answers   TCS, TSC,

why u choose ece

4 Answers  

what is difference b/w watt loss and watt full devices. what is watt loss and watt full devices?

0 Answers  

What is Not-So-Stubby (NSSA)in Open Shortest Path First?

0 Answers  

What is a demultiplexer?

0 Answers  

Why are there two Ground pins on DIP (Dual In-line Package) of 8086 Microprocessor IC ?

3 Answers   Intel, Reliance,