Answer / rajkumar

starting from your control desk terminal --- i/o details in
i/o cards of ur DCS or PLC ---terminal block details of i/o
rack cabinet----any marshalling cabinets in between that
terminal details---any interface in power room ie.. like
motor control panels---- then field junction box terminal
details---- then final field devices like txr or valve or
motor terminal details. Then you can finish your loop
drawing joining control room /i/o cabinet/marshalling
cabinet/ power interface room if exists/field jn box/field
device terminal.
I hope this will do!
Regards

who discoverd ohms law?

6 Answers   HPCL, Patni,

---

how to measure draft pressure in transmitter pl. give its single line digram

0 Answers  

---

On drum level, why we are using air to close Control valve?

4 Answers   L&T,

---

WHICH INSTRUMENT USED TO CALIBRATE CONTROL VALVE?

8 Answers  

---

Absolute pressure is 700psi,what will be the gauge pressure?

1 Answers   IFFCO,

---

a pressure transmitter with a range of 0 to 2500kpag has a specified accuracy of 0.5 % of span.It is to be calibrated using a comparison gauge to have an accuracy of 0.1% of span.The comparison gauge has a range of 0 to 3000kpag What is the accuracy ratio? is this ratio acceptable?

2 Answers  

---

Give me best instrumentation Books name..Ple...

6 Answers  

---

What is furnace draft control?

0 Answers  

---

how to calculate range of Dp transmitter

1 Answers  

---

Difference between guide wave radar & non guide wave radar ?

1 Answers   UPL,

---

what is performance test.need defination

0 Answers   Takreer,

---

What is instrumentation measurement?

0 Answers  

---