What is the difference between rulling span and wind span of
of an Over Head Transmission Line?
No Answer is Posted For this Question
Be the First to Post Answer
we have 1000 litre water tank,it located at 25m hight from ground level,the water level on 10m below from ground level.for fill the tank within 1 hour,how much of motor rating(HP) want to select?
how to interlock 3 nos MCCBs using under voltage coil. please provide me circuit diagram?
What should be the minimum depth of ground laid 66 kv ht cable?
how rating of transformer is selected for any new plant/what kind of load is cosidered/what kind of fadtors are considered/ pz give standard procedure
what is power factor
How to run a three phase motor into single phase........
HOW TO CALCULATE THE SIZE OF CABLE COPPER & ALUMINIUM
11 Answers Amman Try, Prestige,
how can calculated the rating of the 11 KV transformer?
I need the recommended size for a 3 phase transformer at 13.8 KV Primary and connected loads of 3000 kVA at 4200 volts and 2375 kVA @ 480 volts AC.
1000 W bulb takes 4.16 Amps at 240 volt then what will be the KWH & if i am using 1000 W bulb at 180 Volt the amps will be 5.55 then what will be KWH????????????????
why we use only sine wave in ac why we do not use other wave forms
How to do fabrication , busbar and wiring cost for : 1. LT Panels 2. C& R Panel
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)