how to CHECK CT AND PT AT THE FAULT OCCUR IN GENERATOR
RELAY PANEL .
No Answer is Posted For this Question
Be the First to Post Answer
what is the best transformer oil breakdown voltage?
the winding of Gen and Motor is star or in delta ??? and why
Generally In transformer Tap Changer on HT side, but I have seen in 66KV side in 220/66 KV, 100 MVA, Areva make transformer. Why ?
Relay setting for earth fault of reciprocating and centrifugal compressor motor feeder.Setting will be different or same?
what is infinite in infinite bus
what is a FACTS devices? what is mean by STATCOM????
what is battery impedance testing and how we perform this test with four wires.
What are the advantages and disadvantages of negative feed back?
why use celling fan wing is two or three ?
Why the Potential transformer Primary in connected to Earth?
How is the gain affected by the introduction of feedback in a control system.
kindly tell me how the load on generator increase by just increasing the fuel of prime mover, as if for exampple 20 MW gen set is synchronized the load ramps from zero to 20 MW gradully and during this procress only fuel of prime mover increases. Which thing determines the load on generator with respect to fuel