Answer / denzel101

it is a relay that checks for current balance between the
primary and the secondary side of a transformer.it is also
used in other components of the power system like to
protect cables.it is also known as a unit protection as it
does not discriminate with any other protection schemes.the
ct secondary currents that circulates in the coil of this
relay from primary and secondary of the transformer
cancells each other when the system is healthy.when the
fault occurs in a system the balance is disturbed and the
resultant current activate the relay and cause trip.

Answer / manikandan

actually differential relay function in transformer . this
relay monitoring the both side current(primary and seconday)
if current diffrent occure in transformer i t will be trip
the incoming breaker.

Answer / debajit ghosh

The differential relay calculate the current of primary
side and secondery side within the ratio.

Answer / charu manchanda

a differential relay is a protective element which finds the
fault or difference between the primary and secondary current.

Answer / krishnanraman

diff relay generally used for finding the difference in
primary and secondary circuit,the relay connect between the
primary and secondary circuit,normally the current flows
through the primary and through secondary thst time relay
is inoperative mode,when fault occurs the primary changes
as per secondary changed thus relay energise and trip the
circuit

Answer / karthick pdcs

The differential relay which using to check current flow direction.

Answer / durgesh bisht

The differential relay which funtion on failure of the
internal phase and earth fault winding insulation damege
ect.

Answer / gopi

1.buhoolez relay.
2.over current relay.
3.earth leakage relay
4. thermal relay

how to wiring 20 hp motor get completated?

1 Answers   Alchemist,

what is rating boiler

0 Answers  

how to calculate sizing of NGTR (Transformer rating,Loading resistor value and Current rating of resistor) and what is the X/R ratio. Details : 11kV,Capacitance 1.73532 micro farads,40kA for 1sec.

1 Answers   Bhel, Indorama, Power Grid,

Why inductor short on dc and capacitor allow to flow ac?

1 Answers  

What happen if we give resistance to the armatuure of a dc motor?a

1 Answers  

A group of machines (wind turbines) connected with 33KV feeder and each machines are having individual VCB. The 33KV feeder connected with 110KV/33KV substation. The 33KV feeder tripped by over current at Substation and fault recorded at Substation as OC-R&Y phase. Same time the group of machines VCB tripped by over voltage, the fault recorded voltage was above 66KV by numerical Under/Over voltage relay. While grid drop time, this much of voltage hike is possible?

1 Answers  

What is mathematical model of a control system?

0 Answers  

what happen if the supply is given to the stator of the 3phase induction motor with out assembling the rotor ?

0 Answers  

In transformer which temp should be less oil temp are winding temp?

7 Answers   TCS,

what is the impedance voltage of transformer?

1 Answers   AVI Enterprises, MacLellan,

what is ten delta test? what is the significanse of it

1 Answers  

in india why 50 hz and 220 volt taken as standard rating for equipments whereas in US 100hz and 110v is consided as standard rating.is this method save power.

5 Answers   Wipro,