Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / krishnanraman
diff relay generally used for finding the difference in
primary and secondary circuit,the relay connect between the
primary and secondary circuit,normally the current flows
through the primary and through secondary thst time relay
is inoperative mode,when fault occurs the primary changes
as per secondary changed thus relay energise and trip the
circuit
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
why on delay timer used for fully automatic star delta starter?
Please send 110 kv sb station full single line drawing(sld)
where is the need for short circuit test for 3 see is required and why? can you explain in brief with application
1) What are your personal strength? 2) What are your personal areas of improvement? 3) What are your expectations from from a particular job? 4) what are your carrier objectives?
Define delay time.
In ht capacitor ckt we are using LBS Panel it having isolator with fuse, one of HT fuse flash over, so what is reason behind this event.
What is superposition theorem?
I meggared my 2c*70 sq mm AL AR XLPE cable. its one end show 50 M ohm . is my cable is safe for laying. I have only one phase and neutral.
How can find thermal state value in relay for calculate thermal overload.
why ct's&pt'S out put called as burden,why compelsary short ckt the secondary of ct's while removing the burden?
Why do we use copper cable for HT Supply and why not Aluminium?
WHat is the requirement of installing FAST ACTING EARTH SWITCH in GIS and how is that integrated with protection system. How and when does it operate?
A 100W electric lamp is supplied from a 115V, 60HZ source. The peak instantaneous power dissipated in the lamp filament is
i need list of swg(standard wire guage) or area of conductor v/s current carrying capacity of conductor copper & alluminium...
compare between starting charactristics of synchronous motor with those of 3Q Squirrel cage induction motor
