how the reverse power relay acts..
Answers were Sorted based on User's Feedback
Answer / j benedict
With two are more parallel engine generators on line: The
generator with loss of power (rpms if isolated) would draw
power from bus. This power is reverse power and need to
remove this engine generator off of load. The loss of
power on a skid causes could be governor, fuel, ignition
that results in poor engine proformance. RPMS and torque is
real power.
| Is This Answer Correct ? | 3 Yes | 0 No |
Answer / aniruddh
Revese powe4r relay comes in action when the power flow
direction reverse when primemover faliar or lost of
exitation.
it use to prevent genrator for motoring acion.
| Is This Answer Correct ? | 4 Yes | 4 No |
how the frequency was generated in power station
How to calculate the fuel consumption for 600kva DG genset which connecting with 25%load?
How will be the single line diagram of series trip HT breaker? how it works?
in a solar power plant,we are going to step up the voltage 350V to 33kv, and to 132kv GSS. i want to ask that if it is possible that 315v/33kv is not possible because we also use 315v/11kv. or it should be 415v/33kv? is it effects generation or losses? the second question is-generation is depends on LV winding? or LV winding design for generation voltage?
If DC supply is given to a transformer it may a) Work b)Not Work c)Give lower voltage than the rated voltage on secondary side. d)burn the winding
What are the protections for safe running of electric generator?
How can calculate the daily electrical consumption of 7.5 HP motor, if the moter runs 24 hrs continiously. Also have to know about 3.5 hp chiller.
state the construction of incondenscent lamp?
when u are given a timer,push buttons and contactor, how do i practically make a star delta control circuit and a direct online control circuit?
say a transformer is designed for 33/11kv step down with ratio 0.33 for load 1 mva. if am giving 11kv as a input that same transformer what will happen to its o/p voltage. and whether it can be operated for 500kva
is any body explain me why return current in three phase power system is less then in a red, yellow, blue phases??? as we know Ir+Iy+Ib=In then why nutral wire has less then phase current????
Pl.brief me any electrical major fault you have rectified.
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)